The STAR experiment

The high voltage control program has two configuration files that need to be created prior to the utilization of the program. Those files are:

1. default.ini

   This is the basic configuration file. In this file there is information about the high voltage database file, which box and CW-Base need to be turned on, serial line settings and other configuration stuff. This file do not need to be edited by hand. There is a special window in the high voltage program that can be used to modify this file.

 

There are a few commands for expert operation. They are:

1. Led Ampl. entry box

   This Configures the LED pulser amplitude. Enter the value and press [Set] to set it for all the tower crates

Steve Trentalange (on site all run) e-mail: trent@physics.ucla.edu
Phone: x1038 (BNL) or (323) 610-4724 (cell)

Oleg Tsai (on site all run) e-mail: tsai@physics.ucla.edu

SMD High Voltage Operation Manual

Version 1.00
11/12/03, O.D.Tsai

Overview

Overview

This program is designed to control the high voltage of  towers PMT's (Photo Multiplier Tubes). Each tube has an independent high voltage settings. Each PMT is connect to a CW-Base that controls the high voltage for the base. The CW-Base connects to a personal computer running Windows through a RS-485 serial line. The personal computer runs a LabView program that communicates to all CW-Bases in the system to set and monitor the high voltage on each PMT. 

Hello,
At todays meeting I'd like to present my my results on lambda correlations
http://www.star.bnl.gov/protected/hbt/radman/ffrff.htm

If it is not a problem I'd like to start no sooner than at